
8kVA Standby — Farmhouse
Automatic backup for lights, heating and freezers, sized honestly to a real budget with automatic transfer so it starts itself.
Read case studyGenerator installation, servicing, repair and off-grid power for agricultural and rural properties — three-phase, standby and remote-site power, designed around the way the place actually runs.
A farm or estate puts demands on power that a suburban property never sees — and they're the places where an outage does the most damage. When the grid drops, it's not just the lights: it's the milking, the grain dryer, the borehole pump, the freezers full of stock and the security on an empty lodge.
These sites tend to share the same awkward mix: long cable runs and difficult access, large motor loads that surge hard when they start, three-phase machinery, and a grid connection at the end of a rural spur that was never robust to begin with. Add the seasonal peaks — lambing and calving, harvest and grain drying, a full house of holiday lets in August — and "usually works" stops being good enough.
We design around how the place runs, not around a catalogue: the loads that genuinely have to ride through an outage, sized honestly, with the electrical work around them handled by the same person who specified the set.
Automatic backup that keeps heating, water, freezers and essential circuits running through an outage — without anyone having to be there to start it.
Grain dryers, milking parlours, workshops and pumps that need three-phase — supplied where there's no adequate mains, or wired in with the changeover to run it properly.
The loads that can't simply stop. Sized properly for the surge a pump draws the instant it starts, not just its running figure.
Dependable power for let properties and estate cottages, where an outage isn't just an inconvenience — it's a refund and a review.
Complete independent supply where there's no mains, or generator, solar and battery combined to cut fuel and running hours.
Annual servicing, repair and replacement for generators of any make or age — including equipment we didn't install.

On a farm or estate the generator is rarely a standalone job — it's tied into changeover, distribution, three-phase supplies and the general wiring around it. We handle the lot: the set is sized, installed, commissioned under load and handed over, and the electrical work around it is done by the same person, so it's one point of contact from design to sign-off.
That matters when something needs looking at years later — you're not chasing three different trades to work out whose job it was.
How we install generators
Automatic backup for lights, heating and freezers, sized honestly to a real budget with automatic transfer so it starts itself.
Read case study
A workshop full of three-phase machinery and no supply to run it. A 23kVA set became the supply, with changeover for whole-property standby.
Read case study
Decades-old estate plant with no support line, held dependable on an annual servicing schedule.
Read case studyNo obligation — tell us about your site and we'll be straight with you about what makes sense.
Farm, estate or rural business — tell us what you're trying to power and how the place runs, and we'll come back with honest advice and a clear price.